S & M Kustomz Forum

Going through the engine I pulled from my Camaro. Used the heads and intake on my Corvette. Going through the parts I have around working at building something. This will be going up for sale when done with option of short block, long block or complete. This could even be setup with a tune port intake and custom tune. Will have pictures of everything as it goes here.

Finally getting to the engine I pulled from the IROC. Got a used GM performance cam for it and changed it back to a roller. Added a new timing chain and fixing to close the front of the engine up. There is a two piece timing cover installed on this one too. Got a rebuilt set of heads for it. Just need to finish getting them back together and ready to go on. I may go ahead and put together another tune port intake for it too. Thinking of setting this one up speed density too so there will be no need for the mass air flow sensor.

Haven't work on this one in a while. Figured it was time to get it finished up since the run stand is back up here in the garage. Got the heads back on it and working at getting the rest of it together. This is still going to be sold when done.

Here's where it's at today. There will be more on this soon.